promox ve 接入zerotier

canoziia
2022-03-12 / 0 评论 / 669 阅读 / 正在检测是否收录...

先正常安装

curl -s https://install.zerotier.com | sudo bash

然后加入网络

zerotier-cli join xxx

再在pve的/etc/network/interfaces添加

auto vmbr1
iface vmbr1 inet static
        address 192.168.20.1/24
        bridge-ports none
        bridge-stp off
        bridge-fd 0
        post-up zerotier-cli leave xxx
        post-up zerotier-cli join xxx
        post-up   echo 1 > /proc/sys/net/ipv4/ip_forward
        post-up   iptables -t nat -A POSTROUTING -s '192.168.20.0/24' -o vmbr0 -j MASQUERADE
        post-down iptables -t nat -D POSTROUTING -s '192.168.20.0/24' -o vmbr0 -j MASQUERADE

vmbr0是有正常网络的接口

zerotier控制面板加一个route即可。

然后就可以建立集群等等

1

评论 (0)

取消